Accessories

Details & Specifications

Video Paint / Ultimatte®

FINISH:  Matte

SOLVENT: Water.

BINDER TYPE: Vinyl Acrylic.

DILUTION: Use straight out of the can.
If necessary, dilute with water. Diluting Ultimatte paint may make coverage less even.

SURFACE PREPARATION: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces, except fabrics, using Rosco Tough Prime. If painting a new plaster surface, prime wall with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough prime as a final preparation.

APPLICATION: Stir contents before use. Do not shake. Apply by brush, roller, or spray gun. Apply in thin, even, uniform coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge. Change roller direction often to avoid patterns and streaking.

FILM THICKNESS: 2 mil. Dry Film.

COVERAGE: Appx 300 sq. ft. per gallon.

AVG. DRY TIME: At 24°C dries to the touch in 30 minutes. Can be re-coated in 1-2 hours.

CLEAN-UP: Soap and water.

SHELF LIFE: Minimum 24 months.

PACKAGING: 1 Gallon (3,79 l) Cans

COLOR SPECIFICATIONS:

Video levels when 89.9% white is at 100.     Red     Green     Blue
#5720 Rosco Ultimatte® Blue                        22         40         82
#5722 Rosco Ultimatte® Super Blue               7          18         72
#5721 Rosco Ultimatte® Green                     29          84         36

These values were measured with an Ikegami EC-35 camera with Plumbicon tubes. The iris was set so that an 89.9% reflective chip on a Porta Pattern 11 step chip chart was at 100IRE units. The gamma was set to 0.45 and the knee circuit was turned off. Different cameras may yield different levels even under the same conditions.

CAUTIONS: Do not apply when surface or air temperatures are below 50°F. Keep from freezing. Avoid prolonged contact with skin or breathing of spray. Do not take internally. Use adequate ventilation. KEEP OUT OF REACH OF CHILDREN.